Blower Assembly - Passenger Side

Blower Assembly - Passenger Side

Removal
1. Open the bonnet and disconnect the battery earth lead.
2. Remove the right hand side dash liner.
3. Remove the lower screw securing the central processor, displace the earth lead and remove the spacers.
4. Loosen the upper screw securing the processor, raise and disengage the processor from the securing screw.
5. Displace the processor downwards for access.
6. Remove the screws securing the processor mounting bracket and remove the bracket.
7. Displace the pliable trunking from the air conditioning unit.
8. Remove the bolts securing the blower motor assembly.
9. Disconnect the multi-plug cable harness connectors.
10. Disconnect the in-car sensor hose from the pliable trunking.
11. Disconnect the vacuum hose from the blower motor assembly servo unit.





12. Displace and remove the blower motor assembly.
13. Disconnect the ambient temperature sensor.
14. Remove the rubber gasket from the assembly.
15. Remove the tape securing the trunking to the blower motor assembly and remove the trunking.

NOTE: Installation is the reverse of the removal procedure.