Ignition Coil: Service and Repair

IGNITION COIL





RENEW

The ignition coil is a Bosch type TC 1 and is secured to the right-hand inner wing valance.

Open the bonnet and disconnect the battery earth lead.
Displace the LT terminal rubber protective covers and disconnect the LT terminal connections from the coil.
Remove the coil retaining bracket inner and outer securing bolts.
Displace the suppression capacitor, disconnect the HT lead and remove the coil assembly.
Remove the bracket from the coil and discard the coil.
Fit the bracket to the new coil, position the coil and fit the bracket inner and outer securing bolts ensuring that the suppression capacitor bracket is below the inner bolt and the earth eyelet of the LT leads is below the outer bolt.
Tighten the bracket securing bolts to the correct torque and connect the LT leads.
Fit the LT terminal rubber protective covers and connect the HT lead.
Connect the battery earth lead and close the bonnet.