Reinstallation Procedure:

^ Install the new switch(es) to the accumulator body and tighten.


CAUTION: Ensure that no debris/contamination enters the accumulator.





^ Position the harness pins through the anti-back-out plate and seal. Fully install the pins into their correct positions in the multi-plug (refer to chart and Fig. 2 below)


^ Fully seat the seal and anti-back-out-plate into the multi-plug socket.

^ Using insulating tape, tape the two switch harnesses together.

^ Feed the accumulator harness up through the engine compartment to the socket.


NOTE: Make sure that the plug and socket pin connections are clean and free from any oil contamination before connecting them together.


^ Lower the vehicle and connect RS25 plug and socket. Secure using a tie wrap.

^ Start the engine and allow the hydraulic system to pressurize. Check the system for any leaks.

^ Check and top up the hydraulic system if necessary. Use only the recommended HSMO and do not overfill the reservoir.