Instrument Panel Veneer
RENEW
- Disconnect the vehicle battery.
- Remove the drivers side dash liner. Service and Repair
- Remove the instrument housing.
- Place suitable protection on a bench and position the instrument panel face down on the protection.
- Release the retaining clips securing the rear half of the instrument pack and pivot down for access. Remove the warning lamp bulbs adjacent to the instrument pack hinges for access to the screws.
- Carefully reposition the flexible circuit board for access to the upper veneer panel securing screws.
- Remove the upper screws securing the veneer panel.
- Disconnect the flexible circuit board connector from the LCD unit.
- Remove the screws securing the veneer panel to the LCD unit.
- Remove the remaining screws securing the veneer panel to the instrument pack.
- Remove the clips securing the panel lens to the instrument pack and remove the lens.
- Carefully remove the veneer panel from the instrument pack.
Note: Do not lay the instrument pack on the gauge faces.
- Reassembly and fitting is the reversal of this procedure.