Underscuttle - Mounting Revision

76-108

Revised Underscuttle - Revised Mounting
Method - Installation Instructions

MODEL
Sedan Range 1990 - 1992 MY

DATE 7/95

ISSUE:

Replacement underscuttle panels have only 3 "fir tree" fasteners and do not fit directly in place of the previous panel with 5 "fir tree" fasteners.

ACTION:

To install the revised replacement part in place of the original design, proceed as follows:

1. After removing screws, use dash liner tool # JD 188 to remove the underscuttle from the vehicle.

2. Remove the reinforcement panel.





3. Remove and discard the two captive nuts indicated in Illustration 1.





4. Insert the two new female fir tree retainers (AGU 2522/J) in place of the two captive nuts on the brace as indicated in Illustration 2. (Replace the third female fir tree retainer, if necessary)

5. Secure the reinforcement panel onto under-dash brace using the remaining screws at the lower left and upper right, Illustration 2.

6. Secure the new underscuttle panel (BEC 23962/*) to the vehicle.

PARTS INFORMATION:

DESCRIPTION PART NUMBER

Underscuttle BEC 23962/*
Fir tree fastener KTP 100002
Stud retainer (female) AGU 2522/J