Rear

1. Remove the brake pad spring securing clips (1).
2. Remove the retaining pins (2) and anti-rattle springs (if fitted), remove the brake pads from the caliper (3).

NOTE: Reduce the level of fluid in the reservoir before installing new brake pads.

Figure 1:

3. Push the caliper pistons into the cylinder bores using Girling tool 64932392.
4. Install the new brake pads to the caliper, fiting the antirattle springs (if applicable), retaining pins, and Fit the spring securing clips.
5. Top up the brake fluid reservoir, start and run the engine. Apply the brake pedal several times until the pedal travel feels solid.