Steering and Suspension: Testing and Inspection

NOTE: Always adjust alignment settings in the following order:

1. Caster
2. Camber
3. Toe

1. Ensure tires are inflated to correct pressure.
2. Center steering wheel at straight ahead position.
3. Remove grease nipple from rack adjuster pad.

Fig. 1 Toe-in Adjustment:

4. Insert centralizing tool and adjust position of rack until reduced tip of tool enters locating hole in rack.
5. Check alignment by using light beam equipment or an approved track setting gauge.
6. Remove steering levers.

Fig. 2 Steering Lever Dimensions:

7. Accurately check dimensions of each lever against specifications shown.
8. Replace any lever not within specifications.