Section F

SECTION F - REPAIR PROCEDURE
Installation Of Extended Plenum Drain Tube

61. At the rear of the engine compartment, locate and cut away the ratchet strap retaining the drain tube of the plenum chamber. Remove and discard the existing "short" drain tube. Note that the tip of the drain tube is positioned "across" the vehicle.




62. Replace the drain tube with an "Extended" length drain tube (Part No LMB 7OOOBA). Position the tip of the drain tube "in line" with the vehicle; the slit in one face of the rubber tube should face the right hand inner fender of the vehicle. See Fig. 7.
63. Secure the drain, using a ratchet strap (Part No. C46294). Cut off the protruding tail of the strap.