Muffler to Condenser

Muffler To Condenser
- Disconnect battery earth lead.
- As required, depressurize the air conditioning system.

WARNING: Do not vent refrigerant directly to atmosphere and always use Jaguar approved recovery/recycle/recharge equipment. Wear suitable eye and skin protection. Do not mix HFC 134a with CFC 12. Observe all applicable safety requirements.





- Release the discharge hose tube nut at the muffler and displace the hose.
^ Torque: 16.5-23.5 Nm (12.2-17.3 ft lb)
- Fit blanking plugs to the hose and muffler.





- Release the discharge hose sleeve nut (quick fit connector) at the condenser and displace the hose. The sleeve nut must be fully disengaged before the hose may be withdrawn.
^ Torque: 10-14 Nm (7.3-10.3 ft lb)
- Fit blanking plugs to the hose and condenser. Remove discharge hose from vehicle.

NOTE: Installation is the reverse of this procedure. ALL "O" rings must be replaced. "O" rings must be lightly lubricated prior to assembly with Suniso 5GS or similar oil. Seat all fixings before finally tightening to torque.