Coolant Level Sensor: Service and Repair

LOW COOLANT LEVEL PROBE

6 Cyl:

12 Cyl:

RENEW

WARNING! THE PROCEDURE DESCRIBED BELOW SHOULD ONLY BE CARRIED OUT ON A COLD ENGINE.

Disconnect the battery earth lead.
Open the bonnet and fit wing protection covers.
Slacken the coolant reservoir cap to remove any residual pressure.
Tighten the cap.
Disconnect the harness multi-plug and release the harness securing clips.
Using finger pressure, rotate the probe anti-clockwise 1/8th turn and remove, discard the '0' ring.

Fit a new probe complete with a new '0' ring into position.
Press down, and rotate the probe 1/8th turn clockwise to tighten.
Reconnect the harness and secure with retaining clips.
Remove the wing protection covers and close the bonnet.
Reconnect the battery earth lead.