Idle Speed/Throttle Actuator - Electronic: Service and Repair

Remove
- Disconnect battery.
- - Remove the intake elbow to throttle housing hose.
- Disconnect idle speed control valve multi-plug.
- Disconnect throttle potentiometer multi-plug.
- Remove clevis pin circlip.
- Reposition link arm from quadrant.
- Disconnect kick down cable (where fitted) from quadrant.
- Open throttle fully and disconnect inner cable from quadrant.
- Carefully release throttle against stop.
- Fit pipe clamps to throttle body heater feed and return hose.
- Disconnect feed hose from throttle body stub pipe.
- Remove throttle body assembly from inlet manifold.
- Remove idle speed control valve from throttle body.
- Remove gasket.
- Retrieve distance piece from throttle body recess.

Refit in the reverse order of the removal procedure.