Rotary Switch

TRANSMISSION ROTARY SWITCH, ADJUST

- Raise the vehicle on a ramp.

- Position the shift lever to 'N' ensuring that the stalk enters the gate 'N' notch centrally.





- Release and remove the transmission unit rotary switch protection cover (1 Fig.1) to fluid pan bolts.

- Remove the rotary switch protection cover from the fluid pan bosses.

- Slacken the rotary switch to mounting bracket securing nuts.

- Displace the rubber blanking plug from the rotary switch center boss (2 Fig.1).





- Fit Service Tool JD161 (Fig.2) to the rotary switch to align the switch rotor with the switch body.

CAUTION: Service Tool JD161 is a precision tool and should be treated as such.

- Evenly torque tighten the rotary switch to mounting bracket securing nuts.

- Disengage and remove Service Tool JD1 61 from the rotary switch.

- Fully seat the rubber blanking plug into the rotary switch center boss.

- Fit the rotary switch protection cover and align with the fluid pan bosses

- Fit and torque tighten the rotary switch protection cover to fluid pan securing bolts.

- Lower the vehicle on the ramp.

- Check for correct operation of start inhibit and gear selection.