OBDII Report (JTP627/1)

The OBDII report software has been modified to enable the data to be transferred directly to the Multimedia PC and then printed in the form of an S93 report. When OBDII report is selected the PDU will provide instructions to connect to the vehicle. As much information as possible will be gathered directly from the vehicle. Any data that cannot be gathered will be requested by the PDU to be input manually via the on screen keypad. When all of the information has been gathered the PDU will provide a menu screen.

One of the options will be TRANSMIT DATA, after selecting this the PDU will provide instructions to disconnect the PDU from the vehicle and connect to the multimedia PC. Once connected to the PC, with the PC switched on, the only further operation is to press the TICK icon on the PDU to confirm connection. The PDU will transmit all of the OBDII data to the PC.





When the data has been transferred the PC will provide a pop-up screen as shown.

Finished - Exits the screen and saves the S93 OBDII report in the data depository.

Note:
This button will not activate until a MIL Condition has been selected.

Display Panels

VIN Number - Displays the VIN relevant to the data transmitted by the PDU.

Note:
This panel can not be edited.

Complaint Condition - Allows any comments to be added relevant to the report. This field is limited to 255 characters.

Check Boxes
MIL Condition - One of four check boxes must be selected, these indicate the reason for the S93 OBDII report.