AW-4

1. Raise and support vehicle, then drain transmission fluid and reinstall oil pan drain plug.
2. Remove upper half of transmission fill tube and disconnect cooler lines at transmission by pressing fitting release tabs and pulling cooler line and fittings out of case.
3. Support engine with safety stand and support transmission with jack.
4. Disconnect or remove transmission, transfer case shift linkage, necessary exhaust components, speedometer cable, front and/or rear propeller shaft, transmission wire harnesses, transfer case vacuum and wire harnesses.
5. Remove rear crossmember, then disconnect transmission throttle cable at engine.
6. disconnect necessary vacuum and fluid hoses, then remove starter motor, converter to driveplate bolts and converter housing to engine bolts.
7. Secure transmission and transfer case assembly (if equipped), to transmission jack with safety chains, then remove transmission.
8. Remove transfer case if transmission is to be overhauled.
9. Reverse procedure to install. On 4WD models, install transfer case on transmission before installing transmission in chassis.