Oil Pump and Rear Case Assembly/Installation

1. Install magnet in front case pocket.
2. Assemble oil pickup screen, connecting hose, and tube.





3. Install new pickup tube O-ring in oil pump.
4. Insert oil pickup tube in oil pump inlet.





5. Position assembled oil pump and pickup tube in rear case. Be sure pickup screen is securely seated in case slot. Also be sure oil pump locating tabs are outside rear case.
6. Apply 3 mm (1/8 inch) wide bead of Mopar gasket maker or silicone adhesive sealer to mounting flange of front case. Work sealer bead around bolt holes.
7. Lift rear case and oil pump and carefully position assembly on front case. Be sure case dowels are aligned and that mode fork rail extends through rear case before seating rear case on front case.





8. Install case attaching bolts. Alignment bolts at each end of case are only ones requiring washers.
9. Tighten case bolts to 27 - 34 Nm (20 - 25 ft. lbs.) torque.