Rear Wiper Motor

Fig. 10 Switch Test.:

1. Place ignition switch in the ACCESSORY position and the wiper switch in the Wash position, then install relay.
2. Using an ohmmeter, turn ignition switch Off, then test rear wiper motor terminal J.
3. If ohmmeter reads infinity, repair open to splice in liftgate harness.
4. Using a voltmeter, test terminal K.
5. If battery voltage is not indicated, refer to Switch Test.
6. Test terminal H.
7. If battery voltage is indicated, replace motor.
8. If battery voltage is not indicated, repair open from R/Wipe relay terminal 3.