With Automatic Transmission

Crankshaft Position Sensor:

REMOVAL
1. Disconnect negative battery cable.
2. Disconnect sensor electrical connector, located near rear of intake manifold.
3. Remove nut holding sensor wiring clip to fuel rail.
4. Remove sensor mounting bolt(s) or nuts.
5. Remove the sensor from vehicle.
6. Remove clip from sensor wiring harness.


INSTALLATION
1. Position camshaft position sensor in transmission housing and install mounting bolt finger tight.
2. Torque sensor mounting bolt(s) to 19 Nm (14 ft-lbs).
3. Connect the electrical connector to the sensor.
4. Install clip on sensor wire.
5. Install clip over fuel rail stud and tighten mounting nut.
6. Reconnect negative battery cable.