Initial Inspection and Adjustment

INITIAL INSPECTION AND ADJUSTMENT
1. Check and adjust shift linkage.

2. Verify line pressure cable operation. Repair or replace cable if it binds or is damaged.

3. Check engine throttle operation. Operate accelerator pedal and observe injector throttle plate movement. Adjust linkage if throttle plate does not reach wide open position.

4. Check and adjust line pressure cable if necessary.

5. Check transmission fluid level when fluid is at normal operating temperature. Start engine. Shift transmission through all gear ranges then back to Neutral. Correct level is to Full or Add mark on dip-stick with engine at curb idle speed.

6. Check and adjust neutral switch if necessary.

7. Check TPS adjustment and operation. Adjust the sensor if necessary.