Displaying & Reading Trouble Codes

CHECK ENGINE LAMP
To start the function, cycle ignition switch ON-OFF-ON-OFF-ON within 5 seconds and any stored fault code will appear. Check engine lamp will display the code by flashing on and off. There is a short pause between flashes and a longer pause between digits. All codes displayed are 2 digit numbers with a 4 second pause between codes. The lamp will flash until all codes are displayed then 55 (end test) will appear.



SCAN TOOL
1. On 1994-95 models, connect DRB test tool or equivalent scan tool, to Diagnostic Link Connector (DCL) located under the hood.
2. On 1996 models, connect DRB test tool or equivalent scan tool, to DCL located under the instrument panel.
3. On all models, follow scan tool manufactures instructions to access Diagnostic Trouble Codes (DTCs).