Governor and Park Gear

DISASSEMBLY
1. Remove governor body from transmission.





2. Clean and inspect governor filter.





3. Remove snap ring and washer that secure governor weight assembly in body.
4. Remove governor weight assembly from governor body bore.
5. Slide intermediate and inner weight from outer weight.





6. Position intermediate weight on suitable size socket.
7. Push inner weight downward with nut driver. Then remove inner weight snap ring with Miller Plier Tool 6823, or equivalent.
8. Remove inner weight and spring from intermediate weight.

CAUTION: Exercise care when installing the rings. They are easily broken if overspread or twisted during installation.

NOTE: If it was necessary to remove the park gear, inspect the seal rings and bore in rear support. Install new seal rings on park gear hub only if original rings are damaged, or worn. Install ring with interlock ends first and ring with plain ends last. Slip each ring on hub and seat them in grooves. Verify that rear ring ends are securely interlocked before proceeding. If the bore in rear support is damaged. replace the rear support.

ASSEMBLY
1. Lubricate governor components with MOPAR ATF+4 transmission fluid before assembly.
2. Clean and inspect governor weights and bores for scoring or weal. Replace the governor body and weights if damaged.
3. Insert spring into intermediate weight.





4. Insert inner weight into intermediate weight and install snap-ring. Verify snap-ring is fully seated in groove in intermediate weight.
6. Assemble governor weights into governor body.
6. Install washer and snap ring to hold weights in governor body.
7. Install governor body in transmission