Power Mirror Switch: Service and Repair

REMOVAL

This procedure covers removal of only the stand alone power mirror switch. Vehicles with power windows and power locks have the a power mirror switch integral to the Driver Door Module (DDM). See Body and Frame/Mirrors/
Door Module for the service procedures.

1. Disconnect and isolate the battery negative cable.

Stand-Alone Power Mirror Switch Remove/Install:

2. Using a trim stick or another suitable wide flat-bladed tool, gently pry the edge of the switch out of the trim panel to release the snap clip retainers.
3. Pull the power mirror switch away from the trim panel far enough to access the wire harness connector.
4. Unplug the power mirror switch wire harness connector.
5. Remove the power mirror switch from the vehicle.
6. Reverse the removal procedure to install.