Washer Fluid Level Switch: Service and Repair

REMOVAL
1. Remove the washer reservoir as described.

NOTE: The pivoting float of the washer fluid sensor must be in a horizontal position within the reservoir in order to be removed. With the reservoir empty and held in an upright position, the pivoting float will be oriented to the horizontal position when the sensor connector is pointed straight downwards.

2. Using a trim stick or another suitable wide flat-bladed tool, gently pry the washer fluid level sensor out of the rubber grommet seal. Care must be taken not to damage the reservoir.
3. Remove the rubber grommet seal from the reservoir and discard.
4. Reverse the removal and procedures to install. Always use a new rubber grommet seal on the reservoir.