Glove Box Latch and Handle

Glove Box Components:

Service of all of the glove box components must be performed with the glove box removed from the instrument panel.

WARNING: ON VEHICLES EQUIPPED WITH AIR-BAGS, REFER TO AIRBAG AND SEAT BELTS/AIR BAGS BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIR-BAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.

REMOVAL

Glove Box Latch And Handle
1. Disconnect and isolate the battery negative cable.
2. Remove the glove box from the instrument panel. Glove Box Component Replacement
3. Remove the four screws that secure the glove box latch and handle to the glove box door from the inside of the glove box.
4. Remove the latch and handle from the glove box door.

INSTALLATION

Glove Box Latch And Handle
1. Position the latch and handle onto the glove box door.
2. Install and tighten the four screws that secure the glove box latch and handle to the glove box door from the inside of the glove box. Tighten the screws to 2.2 N.m (20 in. lbs.).
3. Install the glove box onto the instrument panel. Glove Box Component Replacement
4. Reconnect the battery negative cable.