Blower Motor Relay: Service and Repair

WARNING: ON VEHICLES EQUIPPED WITH AIR-BAGS, REFER TO AIRBAG AND SEAT BELTS/AIR BAGS BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the glove box from the instrument panel. Refer to Glove Box in the Body and Frame/Interior Trim/Glove Compartment/Service and Repair for the procedures.

Blower Motor Relay Remove/Install:

3. Locate the blower motor relay through the instrument panel glove box opening. The relay is mounted upright and to the right of the instrument panel harness.
4. Unplug the blower motor relay from its wire harness connector.
INSTALLATION
1. Install the blower motor relay by aligning the relay terminals with the cavities in the wire harness connector and pushing the relay firmly into place.
2. Reinstall the glove box in the instrument panel. Refer to Glove Box in the Body and Frame/Interior Trim/Glove Compartment/Service and Repair for the procedures.
3. Connect the battery negative cable.
4. Test the relay operation.