Instrument Cluster / Carrier

Tighten the three screws that secure the upper mounting flange of the cluster bezel to the instrument panel screws to 2.2 Nm (20 in. lbs.).

Tighten the two screws that secure the lower mounting tabs of the cluster bezel to the instrument panel screws to 2.2 Nm (20 in. lbs.).

Tighten the four screws that secure the instrument cluster to the instrument panel screws to 2.2 Nm (20 in. lbs.).

Tighten the two screws that secure the top of the center bezel to the top of the instrument panel screws to 2.2 Nm (20 in. lbs.).

Tighten the one screw into the back of the ash receiver housing that secures the lower portion of the center bezel to the instrument panel screw to 2.2 Nm (20 in. lbs.).

Tighten the four screws that secure the accessory switch bezel to the instrument panel screws to 2.2 Nm (20 in. lbs.).

Tighten the two nuts that secure the stud on each end of the grab handle to the instrument panel nuts to 5.6 Nm (50 in. lbs.).

Tighten the two screws that secure the grab handle bezel to the instrument panel screws to 2.2 Nm (20 in. lbs.).

Tighten the four nuts that secure the top of the instrument panel to the studs on the top of the dash panel. Tighten the nuts to 12 Nm (105 in. lbs.).

Tighten the three screws that secure each end of the instrument panel to the door hinge pillars screws to 12 Nm (105 in. lbs.).

Tighten the two nuts that secure the lower passenger side airbag module bracket to the studs on the dash panel nuts to 28 Nm (250 in. lbs.).

Tighten the screws around the perimeter that secure the base trim to the instrument panel screws to 2.2 Nm (20 in. lbs.).

Tighten the two screws that secure the 16-way data link wire harness connector to the instrument panel screws to 2.2 Nm (20 in. lbs.).