Extension Housing Seal Replacement

REMOVAL
1. Raise and support vehicle.
2. Remove propeller shaft.

Fig. 13:

3. Using a suitable seal puller or screw with a slide hammer, remove the extension housing seal.

INSTALLATION
1. Clean seal bore of extension housing of any residual sealer material from original seal.

Fig. 14:

2. Using Tool Handle C-4171 and Seal Installer 8212, install new extension housing seal so that the seal is located 0 ± 0.5 mm (0 ± 0.02 inch) to the face of the extension housing.
3. Install propeller shaft.
4. Check and add fluid to transmission as necessary. Refer to the Recommended Lubricant for proper fluid requirements.
5. Lower vehicle.