Power Seat Switch: Service and Repair

REMOVAL AND INSTALLATION
1. Disconnect and isolate the battery negative cable.
2. Remove the three screws that secure the seat cushion side shield to the outboard seat cushion frame,
3. Pull the seat cushion side shield away from the seat cushion frame far enough to access the power seat switch wire harness connector.
4. Unplug the wire harness connector from the power seat switch.
5. Remove the seat cushion side shield from the seat.

Power Seat Switch Remove/Install:

6. Remove the two screws that secure the power seat switch to the inside of the seat cushion side shield.
7. Remove the power seat switch from the seat cushion side shield.
8. Reverse the removal procedures to install. Tighten the mounting screws to 2.2 Nm (20 in. lbs.).