High Pressure Sensor / Switch: Service and Repair

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Unplug the wire harness connector from the dual function high pressure switch or the high pressure cut-off switch, which is mounted to a fitting on the non-flexible section of the discharge line nearest the compressor.
3. Unscrew the high pressure switch from the discharge line fitting.
4. Remove the high pressure switch from the vehicle.
5. Remove the O-ring seal from the discharge line fitting and discard.

INSTALLATION
1. Lubricate a new O-ring seal with clean refrigerant oil and install it on the discharge line fitting. Use only the specified 0-rings as they are made of a special material for the R-134a system. Use only refrigerant oil of the type recommended for the compressor in the vehicle.
2. Install and tighten the high pressure switch on the discharge line fitting.
3. Plug the wire harness connector into the high pressure cut-off switch.
4. Connect the battery negative cable.