P1596

Tests 1 - 2:

Tests 3 - 6:

Tests 7 - 10:

SYMPTOM
P1596-SPEED CONTROL SWITCH ALWAYS HIGH

WHEN MONITORED
With the ignition key ON.

SET CONDITION
An open circuit is detected in the speed control ON/OFF switch circuit. The circuit must be above 4.8 volts for more than 2 minutes to set the DTC.

POSSIBLE CAUSES
- Speed control switch ground circuit open clockspring to S/C switch
- Speed control switch ground circuit open PCM to clockspring
- clockspring signal ground circuit open
- S/C wiring harness observable problem
- Speed control ON/OFF switch
- Speed control SW SIG circuit open PCM to clock spring
- Speed control SW SIG circuit open clockspring to S/C switch
- Speed control switch signal circuit shorted to voltage
- Powertrain control module