Horn: Service and Repair

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Raise and support the vehicle.
3. Remove the front underbody splash shield. Refer to Front Skid Plate for the proper front underbody splash shield removal procedures.

NOTE: Remove the horn and its mounting bracket from the vehicle as a unit. Do not remove the horn from its mounting bracket.

Fig.2 Horn Removal/Install:

4. Remove the screw that secures the horn and mounting bracket unit to the radiator closure panel brace.
5. Lower the horn and mounting bracket unit far enough to access and disconnect the headlamp and dash wire harness horn connector from the horn connector receptacle.
6. Remove the horn and mounting bracket unit from behind the front bumper.

INSTALLATION
1. Position the horn and mounting bracket unit behind the front bumper.
2. Reconnect the headlamp and dash wire harness connector for the horn to the horn connector receptacle.
3. Position the horn and mounting bracket unit to the radiator closure panel brace.
4. Install and tighten the screw that secures the horn and mounting bracket unit to the radiator closure panel brace. Tighten the screw to 28.5 Nm (21 ft. lbs.).
5. Install the front underbody splash shield. Refer to Front Skid Plate for the proper front underbody splash shield installation procedures.
6. Lower the vehicle.
7. Reconnect the battery negative cable.