Horn Relay: Service and Repair

REMOVAL
1. Disconnect and isolate the battery negative cable.

Fig.3 Junction Block Location:

2. Remove the right cowl side inner trim panel from the right cowl side inner panel. Refer to cowl side inner trim panel in Body for the removal procedure.
3. Remove the horn relay by grasping it firmly and pulling it straight out from the receptacle in the junction block.

INSTALLATION
1. Position the horn relay in the proper receptacle in the junction block.
2. Align the horn relay terminals with the terminal cavities in the junction block receptacle.
3. Push firmly and evenly on the top of the horn relay until the terminals are fully seated in the terminal cavities in the junction block receptacle.
4. Reinstall the right cowl side inner trim panel onto the right cowl side inner panel. Refer to cowl side inner trim panel in Body for the installation procedure.
5. Reconnect the battery negative cable.