Disassembly and Assembly
DISASSEMBLY1. Remove the ring gear.
2. Drive out the roll pin holding pinion gear mate shaft with a punch (Fig. 41).
3. Remove pinion gear mate shaft from the differential case and pinion mate gears.
4. Rotate differential side gears and remove pinion mate gears and thrust washers (Fig. 42).
5. Remove differential side gears and thrust washers.
ASSEMBLY
1. Install differential side gears and thrust washers.
2. Install pinion mate gears and thrust washers.
3. Install pinion gear mate shaft. Align the roll pin holes in shaft and the differential case.
4. Install roll pin to hold the pinion mate shaft in the differential case (Fig. 43).
NOTE: Drive roll pin till it bottoms out, then stake the case on the pin in two places 180° apart.
5. Install the ring gear.