Rear Door Stationary Window

DOOR GLASS

REMOVAL

The rear door stationary window glass is bonded to the division bar and is serviced as an assembly.

1. Lower the window glass.
2. Remove the inner and outer beltline weatherstrip.
3. Remove the trim panel and waterdam from door inner panel.

Fig. 1:

4. Remove the screws attaching the division bar/glass to the door (Fig. 1).
5. Tilt the division bar/glass forward and remove it from the door.

INSTALLATION

1. Position the division bar/glass in the door.
2. Install the screws attaching the division bar/glass to the door. Finger tighten the screws.
3. Tighten the upper screw to 6 N.m (5 ft.lbs) torque.
4. Tighten the lower screw to 6 N.m (5 ft.lbs) torque.
5. Install the beltline weatherstrip.
6. Install the door waterdam and trim panel.