Instrument Cluster Self Test

Instrument Cluster Self Test
The Instrument Cluster is capable of performing a manual self test. The self test is actuated by depressing and holding the trip reset button while turning the ignition from the OFF to the ON position. The self test will terminate if the tachometer is greater than 300 RPM, the ignition is turned OFF or the test is complete. The cluster will perform the self test in the following manner:

1. Chime once.
2. Scroll an "8" across the VF.
3. Illuminate the VF decimal point.
4. Display the cluster software level (example: SOF 8.9).
5. Display the last 6 (six) digits of the Vehicle Identification Number (VIN).
6. Display fault codes in the VF display if set or scroll "no FAULTS" if no faults are set.
- ACM - Air Bag Message = bus b8.
- Indicator Open/Short = Airbag
- Panel Sense - Open Circuit = PanEL OPEn.
- PCM - MIL Message = bus b0.
- SKIM - SKIM Message = bus b1.

7. Illuminate all applicable indicators.
- Brake Warning
- Check Gauges
- Cruise
- High Beam
- Low Fuel Warning
- MIL (Malfunction Indicator Lamp)
- PartTime
- Seat Belt
- SKIM
- Upshift

8. Display Speedometer Calibration Points.
9. Display Fuel Gauge Calibration Points.
10. Display Temperature Gauge Calibration Points.
11. Display Tachometer Calibration Points.
12. Display Volt Gauge Calibration Points.
13. Display Oil Gauge Calibration Points.