Security Lamp/Indicator: Description and Operation
SKIS INDICATORA Sentry Key Immobilizer System (SKIS) indicator is standard equipment on all instrument clusters, but is only operational on vehicles equipped with the optional SKIS. The SKIS indicator is located near the upper edge of the instrument cluster overlay, in the upper left quadrant of the cluster. The SKIS indicator consists of a stencil-like cutout of a graphical representation or icon of a key that is circled and crossed-out in the opaque layer of the instrument cluster overlay. The dark outer layer of the overlay prevents the indicator from being clearly visible when it is not illuminated. An amber lens behind the cutout in the opaque layer of the overlay causes the indicator to appear in amber through the translucent outer layer of the overlay when it is illuminated from behind by a Light Emitting Diode (LED) soldered onto the instrument cluster electronic circuit board. The SKIS indicator is serviced as a unit with the instrument cluster.
The Sentry Key Immobilizer System (SKIS) indicator gives an indication to the vehicle operator of the status of the SKIS. This indicator is controlled by the instrument cluster electronic circuit board based upon electronic messages received by the cluster from the Sentry Key Immobilizer Module (SKIM) over the Programmable Communications Interface (PCI) data bus. The SKIS indicator Light Emitting Diode (LED) receives battery current on the instrument cluster electronic circuit board through the fused ignition switch output (run-start) circuit whenever the ignition switch is in the ON or Start positions; therefore, the indicator will always be OFF when the ignition switch is in any position except ON or Start. The LED only illuminates when it is switched to ground by the instrument cluster transistor.
The instrument cluster will turn ON the SKIS indicator for the following reasons:
Bulb Test - Each time the ignition switch is turned to the ON position, the SKIM tells the cluster to illuminate the SKIS indicator for about 3 seconds as a bulb test.
SKIM Lamp-ON Message - Each time the cluster receives a lamp-on message from the SKIM, the SKIS indicator will be illuminated. The indicator can be flashed ON and OFF, or illuminated solid, as dictated by the SKIM message. For more information on the SKIS and the SKIS indicator control parameters, (Refer to VEHICLE THEFT SECURITY - OPERATION). The indicator remains illuminated until the cluster receives a lamp-OFF message from the SKIM or until the ignition switch is turned to the OFF position, whichever occurs first.
Actuator Test - Each time the cluster is put through the actuator test, the SKIS indicator will be turned ON, then OFF again in a prescribed sequence to confirm the functionality of the LED and the cluster control circuitry
The SKIM performs a self-test each time the ignition switch is turned to the ON position to decide whether the system is in good operating condition. The SKIM then sends the proper SKIS lamp-ON or lamp-OFF messages to the instrument cluster. For further diagnosis of the SKIS indicator or the instrument cluster circuitry that controls the indicator, (Refer to INSTRUMENT CLUSTER - DIAGNOSIS AND TESTING). If the instrument cluster turns ON the SKIS indicator after the bulb test, either solid or flashing, it indicates that a SKIS malfunction has occurred or that the SKIS is inoperative. For proper diagnosis of the SKIS, the PCI data bus, or the message inputs to the instrument cluster that control the SKIS indicator, a DRBIII scan tool is required. Refer to the appropriate diagnostic information.