Horn: Service and Repair

REMOVAL
1. Disconnect and isolate the battery negative cable.

Fig.1 Horns Remove/Install:

2. Disconnect the wire harness connectors from the horn connector receptacles.
3. Remove the screw that secures the horn and mounting bracket units to the left front inner fender shield.
4. Remove the horn and mounting bracket units from the left front inner fender shield.

INSTALLATION
1. Position the horn and mounting bracket units onto the left front inner fender shield. Ensure that the anti-rotation tab on the horn bracket is inserted into the hole in the inner fender shield.
2. Install and tighten the screw that secures the horn and mounting bracket units to the left front inner fender shield. Tighten the screw to 101 Nm (75 ft. lbs.).
3. Reconnect the wire harness connectors to the horn connector receptacles.
4. Reconnect the battery negative cable.