Rear Door: Service and Repair

DOOR

REMOVAL




1. Disconnect the door wire harness electrical connector (1) at the B-pillar.
2. Disconnect the check strap from the B-pillar.
3. Support the door with a suitable lifting device.

NOTE: The epoxy washers (3) should not be removed from the hinge. If the washers are removed the door may have to be re-adjusted.




4. Remove the nuts (4) attaching the door hinges to the door (1).

INSTALLATION

1. Support the door with a suitable lifting device and install the door onto the B-pillar.




2. Install the nuts (4), washers (3) and tighten to 23 N.m (17 ft.lbs.).




3. Connect the door wire harness electrical connector (1).
4. Connect the check strap to the B-pillar.
5. Adjust the door as necessary. Refer to Body and Frame / Specifications / Dimensions.