Cargo Lamp Bulb Replacement
REMOVAL1. Disconnect and isolate the battery negative cable.
Fig.4 Cargo Lamp Lens Remove:
2. Using a small thin-bladed screwdriver, gently pry outward on either side near the top of the cargo lamp lens until the lens pivot unsnaps from the pivot pin within the lamp unit housing.
3. Move the cargo lamp lens upward far enough to disengage the switch tab at the bottom of the lens from between the switch plunger and the lamp unit housing.
4. Remove the cargo lamp lens from the lamp unit housing.
Fig.5 Cargo Lamp Bulb Remove/Install:
5. Firmly grasp the cargo lamp bulb and pull each end outward until it is disengaged from its respective bulb holder within the lamp unit housing.
6. Remove the cargo lamp bulb from the lamp unit housing
INSTALLATION
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the socket andlor the lamp wiring.
1. Position the cargo lamp bulb into the lamp unit housing.
2. Align the ends of the cargo lamp bulb with each of the bulb holders within the lamp unit housing.
3. Using hand pressure, press firmly and evenly on both ends of the cargo lamp bulb until they snap into their respective bulb holders within the lamp unit housing.
4. Position the cargo lamp lens to the lamp unit housing.
5. Insert the switch tab at the bottom of the cargo lamp lens between the switch plunger and the lamp unit housing.
6. Align the pivots on each side near the top of the cargo lamp lens with the pivot pins within the lamp unit housing.
7. Using hand pressure, press firmly and evenly on the cargo lamp lens over both pivots until they snap into place over the pivot pins within the lamp unit housing
8. Reconnect the battery negative cable.