Repeater Lamp Bulb Replacement
REMOVALSide repeater lamps are used only on vehicles manufactured for certain markets where these lamps are required.
1. Disconnect and isolate the battery negative cable.
2. Remove the repeater lamp unit from the front fender panel. (Refer to LAMPS/ LIGHTING - EXTERIOR/REPEATER LAMP UNIT - REMOVAL).
Fig.61 Repeater Lamp Bulb Remove/Install:
3. Rotate the repeater lamp socket in the lamp lens counterclockwise about 30 degrees (Fig. 61).
4. Pull the socket and bulb straight out of the repeater lamp lens.
5. Pull the bulb straight out of the repeater lamp socket.
INSTALLATION
Side repeater lamps are used only on vehicles manufactured for certain markets where these lamps are required.
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the socket andlor the lamp wiring.
1. Align the base of the bulb with the receptacle in the repeater lamp socket.
2. Push the bulb straight into the repeater lamp socket until it is firmly seated.
3. Align the socket and bulb with the socket opening in the repeater lamp lens (Fig. 61).
4. Push the socket and bulb straight into the repeater lamp lens until it is firmly seated
5. Rotate the repeater lamp socket in the lamp lens clockwise about 30 degrees
6. Reinstall the repeater lamp unit onto the front fender panel. (Refer to LAMPS/ LIGHTING - EXTERIOR/REPEATER LAMP UNIT - INSTALLATION).
7. Reconnect the battery negative cable.