Repeater Lamp Unit Replacement

REMOVAL
Side repeater lamps are used only on vehicles manufactured for certain markets where these lamps are required.
1. Disconnect and isolate the battery negative cable.

Fig.62 Repeater Lamp Unit Remove/Install:

2. Using a trim stick or another suitable wide flat-bladed tool, carefully pry at the clearance notch in the lower edge of the repeater lamp lens to disengage the snap features of the lens from the mounting hole in the front fender panel (Fig. 62).
3. Pull the repeater lamp unit out from the front fender panel far enough to access and disconnect the repeater lamp wire harness connector from the connector receptacle on the back of the repeater lamp unit socket.
4. Remove the repeater lamp unit from the front fender panel.

INSTALLATION
Side repeater lamps are used only on vehicles manufactured for certain markets where these lamps are required.
1. Position the repeater lamp unit to the front fender panel (Fig. 62).
2. Reconnect the repeater lamp wire harness connector to the connector receptacle on the back of the repeater lamp unit socket.
3. Position the repeater lamp unit into the mounting hole in the front fender panel. Be certain that the clearance notch on the edge of the repeater lamp lens is oriented toward the bottom.
4. Using hand pressure, press on the repeater lamp unit firmly and evenly until the snap features of the lens are fully engaged in the mounting hole of the front fender panel.
5. Reconnect the battery negative cable.