Antenna Body and Cable - Export

ANTENNA BODY AND CABLE - EXPORT

REMOVAL

WARNING: DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, SEAT BELT TENSIONER, SIDE AIRBAG, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE AIRBAG SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE AIRBAG SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIR-BAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.

1. Disconnect and isolate the battery negative cable.
2. Remove the assist handles on the right side of the headliner.
3. Remove the right side visor.
4. Remove the A-pillar trim.

Fig.4 Antenna Cable:

5. Lower headliner as necessary to access antenna cable.
6. Disconnect antenna cable from antenna module.
7. Remove antenna cable from roof panel by pulling on retaining clips.
8. Disconnect antenna cable from instrument panel antenna cable by disconnecting the antenna connector.

INSTALLATION

1. Connect antenna cable to the instrument panel antenna cable.
2. Install antenna cable to the roof panel by pressing retaining clips into position.
3. Connect antenna cable to the antenna module.
4. Raise headliner into position.
5. Install A-pillar trim .
6. Install the right side sunvisor.
7. Install the assist handles.
8. Connect the battery negative cable.