PDC B+ Terminal Module
REMOVAL1. Remove the PDC housing lower cover.
Fig.10 PDC B(+) Terminal Module Latches:
2. From the top of the PDC housing, use a small screwdriver or a terminal pick tool (Special Tool Kit 6680) to release the two latches that secure the B(+) terminal module in the PDC (Fig. 10).
3. Gently and evenly press the two B(+) terminal studs down through the bus bar in the PDC.
Fig.11 PDC B(+) Terminal Module Remove/Install:
4. From the bottom of the PDC housing, remove the B(+) terminal module from the PDC (Fig. 11).
INSTALLATION
1. From the bottom of the PDC housing, align and insert the B(+) terminal module into the PDC.
2. From the bottom of the PDC housing, align and insert the two studs of the PDC B(+) terminal module through the bus bar in the PDC.
3. From the bottom of the PDC housing, press the B(+) terminal module gently and evenly into the PDC until both of the latches are fully engaged.
4. Install the PDC housing lower cover.