Wiper on/Off Relay Replacement

REMOVAL
1. Disconnect and isolate the battery negative cable.

Fig.30 Power Distribution Center:

2. Remove the cover from the Power Distribution Center (PDC) .
3. Remove the wiper ON/OFF relay by grasping it firmly and pulling it straight out from the receptacle in the PDC.

INSTALLATION
1. Position the wiper ON/OFF relay to the proper receptacle in the Power Distribution Center (PDC).
2. Align the wiper ON/OFF relay terminals with the terminal cavities in the PDC receptacle.
3. Push firmly and evenly on the top of the wiper ON/OFF relay until the terminals are fully seated in the terminal cavities in the PDC receptacle.
4. Reinstall the cover onto the PDC.
5. Reconnect the battery negative cable.