NV231 - Transfer Case
REMOVAL / NV231 Transfer Case1. Raise and support the vehicle.
2. Disengage the transfer case position sensor connector from the position sensor.
3. Remove the position sensor from the transfer case.
INSTALLATION / NV231 Transfer Case
1. Inspect the O-ring seal on the transfer case position sensor. Replace the O-ring if necessary.
2. Install the transfer case position sensor into the transfer case.
Transfer Case Position Sensor 20 - 34 Nm (15 - 25 ft. lbs.)
3. Engage the transfer case position sensor connector to the position sensor.
4. Lower vehicle.
5. Verify proper sensor operation.