Front Position Lamp

NOTE: The front position lamps are integral to the headlamps on vehicles manufactured for certain markets where these lamps are required.

REMOVAL

BULB
1. Disconnect and isolate the battery negative cable.
2. Remove the headlamp from the front grille opening reinforcement.

Front Position Lamp Remove/Install:

3. Firmly grasp the front position lamp socket near the bottom of the headlamp unit housing and rotate it counterclockwise about 30 degrees to unlock it.
4. Pull the socket and bulb straight out from the keyed opening in the housing.
5. Pull the base of the bulb straight out of the socket.

INSTALLATION

CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the socket and/or the lamp wiring.

1. Align the base of the bulb with the position lamp bulb socket.
2. Push the bulb straight into the socket until the base is firmly seated.
3. Align the socket and bulb with the keyed opening on the bottom of the headlamp housing.
4. Insert the socket and bulb into the housing until the socket is firmly seated.
5. Rotate the socket clockwise about 30 degrees to lock it into place.
6. Reinstall the headlamp unit onto the grille opening reinforcement.
7. Reconnect the battery negative cable.
8. Confirm proper headlamp unit alignment.