Shaft Propeller Rear

SHAFT PROPELLER REAR

REMOVAL
1. With vehicle in neutral, position vehicle on hoist.





2. Mark a reference line (3) (Fig. 11) across companion flanges (2) (4) and propeller shaft (1) for installation.





3. Pry open clamp holding the dust boot (2) (Fig. 12) to propeller shaft yoke, if equipped.





4. On 4x2 vehicles with manual transmission remove transmission companion flange (1) bolts (2) (Fig. 13).
5. Remove pinion companion flange bolts.
6. Remove propeller shaft.

INSTALLATION
1. Slide slip yoke on the transmission/transfer case output shaft. On 4x2 vehicles with a manual transmission install transmission flange bolts and tighten to 115 Nm (85 ft. lbs.).





2. Align reference marks (3) (Fig. 14) on companion flanges (4) and propeller shaft (1).
3. Install companion flange bolts and tighten to 115 Nm (85 ft. lbs.).





4. Tighten dust boot (3) (Fig. 15) clamp (4) if equipped with Clamp C-4975A (1).