Repeater Lamp

NOTE: Side repeater lamps are used only on vehicles manufactured for certain markets where these lamps are required.

REPEATER LAMP

BULB

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the repeater lamp unit from the front fender panel.

Repeater Lamp Bulb Remove/Install:

3. Rotate the repeater lamp socket in the lamp lens counterclockwise about 30 degrees to unlock it.
4. Pull the socket and bulb straight out of the keyed opening in the lamp lens.
5. Pull the base of the bulb straight out of the lamp socket.

INSTALLATION

CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the socket and/or the lamp wiring.

1. Align the base of the bulb with the repeater lamp socket
2. Push the bulb straight into the socket until the base is firmly seated.
3. Align the socket and bulb with the keyed opening on the back of the repeater lamp lens.
4. Insert the socket and bulb straight into the lens until the socket is firmly seated.
5. Rotate the socket clockwise in the lens about 30 degrees to lock it into place.
6. Reinstall the repeater lamp unit onto the front fender panel.
7. Reconnect the battery negative cable

LAMP

REMOVAL
1. Disconnect and isolate the battery negative cable.

Repeater Lamp Unit Remove/Install:

2. Using a trim stick or another suitable wide flat-bladed tool, carefully pry at the clearance notch in the lower edge of the repeater lamp lens to disengage the snap features of the lens from the mounting hole in the front fender panel.
3. Pull the lamp unit out from the front fender panel far enough to access and disconnect the wire harness connector from the lamp socket.
4. Remove the lamp unit from the front fender panel.

INSTALLATION
1. Position the repeater lamp unit to the front fender panel.
2. Reconnect the wire harness connector to the lamp socket.
3. Position the lamp unit into the mounting hole in the front fender panel. Be certain that the clearance notch on the edge of the lamp lens is oriented towards the bottom.
4. Using hand pressure, press on the lamp lens firmly and evenly until the snap features of the lamp are fully engaged in the mounting hole of the front fender panel.
5. Reconnect the battery negative cable.