Switch

HOOD AJAR SWITCH

SWITCH

REMOVAL




1. Unlatch and open the hood.
2. Disconnect and isolate the battery negative cable.
3. From the top of the mounting bracket (3) on the right front fender inner shield (1), squeeze the two hood ajar switch (4) latch tabs together and pull the switch upward.
4. Pull the hood ajar switch up through the hole in the mounting bracket far enough to access and disconnect the wire harness connector (5) from the switch connector receptacle.
5. Remove the hood ajar switch from the mounting bracket.

INSTALLATION




1. Position the hood ajar switch (4) near the hole in the mounting bracket (3) on the right inner fender side shield (1).
2. Pull the wire harness connector (5) through the switch mounting bracket and reconnect it to the switch connector receptacle.
3. From the top of the mounting bracket, press the switch downward into the mounting hole until the integral switch latch tabs lock it into place.
4. Reconnect the battery negative cable.
5. Close and latch the hood.