Front

DOME LAMP

LAMP - FRONT

NOTE: Two different front dome lamps are available, one for vehicles without a sunroof and a second for vehicles with a sunroof. The only differences between these lamps are that the one for sunroof applications has a mount for a power sunroof switch within the lamp housing, an opening in the center of the lamp lens through which the sunroof switch rocker protrudes, and an opening on the back of the lamp housing through which the sunroof switch connector receptacle protrudes. The lamp and bulb service procedures are the same for either lamp.

REMOVAL




1. Disconnect and isolate the battery negative cable.
2. Insert the tip of a small flat bladed screwdriver into the notch (3) between the lens (2) and the housing (1) on one side of the dome lamp unit.
3. Gently pry the end of the lens downward until it unsnaps from the housing.
4. Swing the lens downward until it is perpendicular to the housing.
5. Pull the lens hinge/retainer (4) end of the housing downward slightly from the headliner, then slide the lowered end of the housing away from the mounting hole far enough to disengage the fixed retainer on the notched end from the headliner.
6. Pull the lamp away from the headliner mounting hole far enough to disconnect the wire harness connector from the back of the lamp.
7. If the vehicle is equipped with an optional power sunroof, disconnect the wire harness connector from the sunroof switch connector receptacle on the back of the lamp.
8. Remove the lamp from the vehicle.

INSTALLATION




1. Position the dome lamp unit (1) to the mounting hole in the headliner.
2. Reconnect the wire harness connector to the connector on the back of the lamp.
3. If the vehicle is equipped with an optional power sunroof, reconnect the wire harness connector to the sunroof switch connector receptacle on the back of the lamp.
4. Insert the fixed retainer on the notched end of the lamp housing up into one side of the mounting hole in the headliner.
5. Slide the notched end of the housing into the mounting hole far enough to engage the lens hinge/retainer (4) into the opposite side of the hole in the headliner.
6. Gently and evenly press the lens hinge/retainer end of the lamp upward into the mounting hole until the bezel of the lamp housing is flush with the headliner.
7. Swing the notched end of the lamp lens (2) up into position against the lamp housing, then press upward on the lens firmly and evenly until it snaps into the housing.
8. Reconnect the battery negative cable.