Cover
LAMP BARCOVER
REMOVAL
1. Remove the four screws (2) that secure the cover (1) to the rear edge of the light bar reinforcement (3) on the roof panel.
2. Lift the rear edge of the cover upward and then slide it forward far enough to disengage the front edge of the cover from under the front edge of the light bar reinforcement.
3. Remove the light bar cover from the roof panel.
INSTALLATION
1. Position the front edge of the light bar cover (1) on the roof panel just ahead of the front edge of the light bar reinforcement (3).
2. Slide the cover rearward to engage the front edge of the cover under the forward edge of the reinforcement, then lower the rear edge of the cover into position.
3. Install and tighten the four screws (2) that secure the rear edge of the cover to the reinforcement. Tighten the screws to 2 N.m (17 in. lbs.).